Πώς να φτιάξετε ένα νεσεσέρ μπάνιου | Ξυλουργική DIY



Σε αυτό το βίντεο, θα σας δείξω πώς να φτιάξετε ένα ρουστίκ νεσεσέρ μπάνιου DIY χρησιμοποιώντας 1×3 και 1×4. Αυτό είναι ένα απλό έργο που μπορεί να ολοκληρωθεί χρησιμοποιώντας βασικά εργαλεία, μόνο ένα φαλτσοπρίονο και τρυπάνι, αλλά χρησιμοποίησα περισσότερα εργαλεία από τότε που ξεκίνησα με τραχιά ξυλεία.
Βίντεο και σχόλια από το κανάλι Crafted Workshop


Σου αρέσει; Μοιράσου το με τους φίλους σου!

44 Σχόλια

Your email address will not be published. Required fields are marked *

  1. Мастер, без фугования, заготовки сразу в рейсмус – и все ровно. Круто. Прикольная имитация филенки

  2. Do you think the df500 would’ve been better suited for the job? I am trying to decide which domino to get and I have an upcoming vanity build so wondering if the XL or the df500 would be a good choice for this project

  3. What dust shroud are you using for the SawStop? Unfortunately I didn't get the free overhead arm with mine and have to stuff my Festool hose into the dust shroud which will eventually wear out the hose and dust collections is so-so. I have a 4" DC drop above the saw … do you like your setup over the factory shroud?

  4. Hi Johnny, thank you for the vanity instructions. I did purchase the plans. I wanted to build the dual vanity, and I assume the sketch up plans are for the sketch up plans, which were included. I tried to open the file, but it is in some other language which I can't read. I was wondering if you could help me with that? thank you, Sandra

  5. If the person acquiring wanted inset doors would you have done anything different? I like your design but need inset doors to match the style elsewhere in my home. 🙂

  6. Just like I mentioned on the workbench video last week, I'm getting ready to build a bathroom vanity! It's like you're reading my mind and making content just for me.

  7. Beautiful Johnny, I did have to laugh when you had to mention a measurement in metric 😂😂, that must hurt you as much as me trying to understand imperial mate lol, anyway another top video 👍👍👍👍

  8. Hey Jonny. What is you DC collection setup on your table saw? Do you have a video on that? I remember seeing iypt in you shop for but I don't think you went into detail on it? Also which camp?

  9. On this project's plan page on your website, at the bottom where you have a link to the build video, it points to the computer desk build videos (I am guessing it should point back to this video?). Great video, and I am digging that Cypress. Looks really crisp, clean.